![]() ![]() Center-to-center distance of the holes in the diagonal push rods. and processor overload (too many expensive sqrt calls). This is a trade-off between visible corners (not enough segments) Make delta curves from many straight lines (linear interpolation). ![]() Define this to have the electronics keep the power supply off on startup. 2 = X-Box 360 203Watts (the blue wire connected to PS_ON and the red wire to VCC) Please choose the one that matches your setup // The following define selects which power supply you have. #define BTENABLED // Enable BT interface on AT90USB devices This enables the serial port associated to the Bluetooth interface This determines the communication speed of the printer Serial port 0 is still used by the Arduino bootloader regardless of this setting. This allows the connection of wireless adapters (for instance) to non-default port pins. SERIAL_PORT selects which serial port should be used for communication with the host. #define STRING_CONFIG_H_AUTHOR "(jcrocholl, Mini Kossel)" // Who made the changes. #define STRING_VERSION_CONFIG_H _DATE_ " " _TIME_ // build date and time ![]() build by the user have been successfully uploaded into firmware. Implementation of an idea by Prof Braino to inform user that any changes made to this User-specified version info of this build to display in terminal window during example_configurations/delta directory. For a Delta printer replace the configuration files with the files in the BASIC SETTINGS: select your board type, temperature sensor type, axis scaling, and endstop configuration Advanced settings can be found in Configuration_adv.h This configuration file contains the basic settings. I made a lot of tests with the smoth rod offset but my printer still prints not flat. Very bright girl !!!Īt the moment i use johann rocholls marlin, but i´ve used rich cattel´s too. This way is definitely better, and cheaper and easier to manufacture. The low quality magnets haven't been quite as strong that has led to a couple of times when the rods have let go when homing (never during a print though) I slowed the homing speed a bit and that cured it but I felt there must be a better way. I've had issues getting a regular supply of 10mm magnets that weren't horrendously expensive. I've been struggling with a good implementation for mine, and this new idea looks like a good one. Is the change due to some problem with the magnet plan, or is it more to simplify the design? I haven't quite finished my printer yet, so haven't had a chance to explore the limitations of the magnets.Īlso, I see what you've done with the spring-loaded hotend-placing a cross bar to get both springs on there. The new string-spring plan looks like a good one! ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |